The MT-500 Series is designed for use in a factory environment. It is designed tooperate from 32 to 113 °F (0 to 45 °C) temperatures, as found in most industrialenvironments. It may not be suitable for use in certain outdoor applications. Pleaseconsult the factory for advised usage in outdoor applications.
The MT-500 Series front bezel is NEMA 4 rated. When installed properly in a NEMA4 panel, the NEMA 4 rating of the panel will not be compromised. This means thatfluids will not enter the panel during wash downs.
The MT-500 Series has been tested to conform to European CE requirements. Thismeans that the circuitry is designed to resist the effects of electrical noise. This doesnot guarantee noise immunity in severe cases. Proper wire routing and groundingwill insure proper operation.
Avoid installing units in environments where severe mechanical vibration or shocksare present.
The unit can be mounted into panels with a depth of 4” (105mm). It is recommended that the unit be mounted on the front panel of a steel enclosure, through an appropriate opening*. Allow a clearance of 1”(25mm) around the sides of the unit for mounting hardware. Allow clearance for cable connections to the back of the unit. Unit depth may vary according to cable type used. Typically, plan a depth to accommodate at least 4” (105mm) behind the panel.
Put the unit through the panel cut out. Slide the clamps into the 6 holes provided around the case. Tighten the clamping screws in an even pattern until the unit is secured in the panel.
MT506LV4CN inverter, MT506LV4CN power supply, MT506LV4CN electronic board, MT506LV4CN VGA board, MT506LV4CN touchscreen available.